Opel Astra, Zafira

Since 1998 of release

Repair and car operation

Introduction

The given Management was made to help on purpose to the owner of the car to receive from it the maximum return. Performance of the given problem is reached by several ways. The data collected and presented more low allows the owner of a vehicle to be defined in what works on its service should be spent and when, and also whether has sense to try to execute them independently, or it is necessary to address in representation branch of firm-manufacturer or a car-care centre workshop. Descriptions of procedures of obligatory routine maintenance of the car are included in the Management and the schedule of their performance is resulted. The information on carrying out of diagnostics of malfunctions of knots and car systems (in case of their refusal), and also ways of elimination of their reasons Besides, is offered.

Instructions for use the Management

The management is divided into Chapters. Each Chapter is broken into sections. Sections, in turn, break into subsections and where it is required, on under-subsections and consist of paragraphs.

Brought to attention of readers the text is accompanied by explanatory illustrations.

The description once the procedures mentioned in the text usually the second time does not repeat. Instead the reference to corresponding section (subsection etc.) where the given procedure already met in case of need becomes.

References to knot or component position at the left or on the right on the car are based on the assumption that the reader is on a driver's place the person forward.

Descriptions in the given management are stated in the simple and accessible form. If accurately to follow resulted in the text and on accompanying illustrations to the recommendations, no special difficulties at performance of tasks in view should to arise.

It is necessary to give a proper attention to observance of technical parametres and the requirements shown by the moments of a tightening of carving connections, shown in sections of Specifications and placed in the beginning of each Chapter.

It is necessary to be guided by specifications at performance of all works. In separate Sections the necessary sizes and values for adjustment are resulted not always.

Simple operations as, for example, «to open a cowl» or «to weaken nuts of fastening of a wheel» are meant as self-evident and also are mentioned not always.

On the contrary, in the text the most difficult are in detail described and demanding the raised accuracy at procedure performance.