Opel Astra, Zafira

Since 1998 of release

Repair and car operation


Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Manual transmission
   Specifications
   Adjustment of a drive of a gear change
   Removal and installation of the mechanism of a gear change
   Replacement of epiploons
   Check of serviceability of functioning, removal and installation of the gauge-switch of fires of a backing
   Removal and installation of the gauge of speed (VSS)
   Replacement трансмиссионного oils
   Removal and installation manual transmission
   Repair manual transmission - the general information
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Снижается слух

Replacement of epiploons

Epiploons of power shafts

 PERFORMANCE ORDER

  1. Prop up back wheels противооткатными boots, cock a lay brake, then поддомкратьте redock of the car and establish it on props. Remove a corresponding forward wheel.
  2. Merge трансмиссионное oil (Routine maintenance see the Head).
  3. Remove a power shaft (Coupling and power shafts see the Head).
  1. Accurately having hooked the big screw-driver, take an epiploon from the differential case.
  1. Carefully smooth out walls of a landing nest in the differential case. Grease an external edge of a new epiploon трансмиссионным with oil. Having rested suitable cylindrical оправку against firm external edge of an epiploon, it is accurate запрессуйте its sealing sponges inside заподлицо with a surface of the case of differential.
  2. Establish into place a power shaft (Coupling and power shafts see the Head), - try not to damage an epiploon.
  3. If merged, fill in in manual transmission necessary quantity fresh трансмиссионного oils of corresponding quality (Routine maintenance see the Head). If oil did not merge, correct its level (Routine maintenance see the Head).

Epiploon of a primary shaft

The epiploon is built in the working cylinder and if necessary replaced in gathering with it. Before to come to definitive belief in an epiploon exit out of operation, make sure that it has failed, instead of cheap consolidation of the working cylinder in картере manual transmission, consolidation can be replaced by cylinder removal (Coupling and power shafts see the Head).

Epiploon of a rod of a choice of transfers

Replacement demands removal and dismantling of a cover of the mechanism of a choice of transfers, and it is necessary to charge its performance to experts of car-care centre.