Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
- The engine
Specifications
Check компрессионного pressure in cylinders
Diagnostics of a condition of the engine with vacuum gauge application
+ Procedures of repair of petrol engines SOHC without their extraction from the car
- Procedures of repair of petrol engines DOHC without their extraction from the car
Reduction of the piston of the first cylinder in position of the top dead point of a step of compression (ВМТ)
Removal and cover installation газораспределительного the mechanism
Removal and installation of a pulley of a cranked shaft
Removal and installation of a cover of drive ГРМ
Removal and installation of a belt of drive ГРМ
Removal and installation of cogwheels cranked / camshafts and intermediate rollers
Replacement of epiploons of camshafts
Removal and installation of camshafts and pushers of valves, check of a condition of components
Removal and installation of a head of cylinders
Removal and pallet installation картера
Removal and installation of the gauge of level of impellent oil
Removal, service and installation of the oil pump
Removal, check of a condition and flywheel / installation приводного a disk
Replacement of epiploons of a cranked shaft
Check of a condition and replacement of support of a suspension bracket of the power unit
Removal, installation and adjustment of the balancing mechanism of a cranked shaft (engines 2.0)
+ Procedures of repair of diesel engines of 1.7 l and 2.0 l without their extraction from the car
+ The general and engine major repairs
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a pulley of a cranked shaft
Engines 1.4, 1.6 and 1.8 l Removal and installation of a pulley of a cranked shaft see. Engines of 2.0 l Removal
|
|
- Cock a lay brake, поддомкратьте redock of the car and establish it on props. Remove the right forward wheel and (at a corresponding complete set) protection картера.
- Remove belts of a drive of auxiliary units (Routine maintenance see the Head), — preliminary put on a tape of a belt marks of a direction of its rotation.
|
- Turning a cranked shaft for a pulley bolt, achieve combination of its adjusting label with the index.
|
|
- Ослабьте also turn out small bolts of fastening of a pulley to a cogwheel of a cranked shaft and remove a pulley from the engine, — in case of need keep a shaft from проворачивания for a bolt of fastening of a cogwheel.
|
|
Installation
|
|
- Make sure of correctness of combination of a label of a cogwheel with the index on the case of the oil pump. Accurately establish a pulley of a cranked shaft on a cogwheel, screw fixing bolts and tighten them with demanded effort.
|
|
- Establish belts of a drive of auxiliary units (Routine maintenance see the Head), — track observance of an initial direction of rotation (see the marks put at removal).
- Establish protection картера (tighten fixture with demanded effort).
- Lower the car on the earth, then tighten fastenings of a wheel with demanded effort.
|
|
|
|