Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
- Automatic transmission
   Specifications
   Adjustment of the mechanism of a choice of transfers
   Removal and installation of a cable of a choice of transfers
   Removal and installation of assemblage of the lever of selector AT
   Replacement of epiploons
   Cooler ATF - the general information
   Removal and installation of electric components of control system АТ
   Removal and installation АТ
   Major repairs АТ - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of a cable of a choice of transfers

Removal

 PERFORMANCE ORDER

  1. Remove the central console (the Body see the Head). Translate the selector lever in position Р.
  1. Screw-driver with a flat sting release a clamp and accurately liberate a tip of a cable from a basic arm, then disconnect a cable from a fixing plate in a forward part of the executive lever.
  1. Remove the storage battery with the adjusting pallet (the engine Electric equipment see the Head).
  2. At a corresponding complete set release a clamp and accurately separate a tip of a cable from selector AT lever. Liberate a cover of a cable from a basic arm.
  3. Walk on all length of a cable from transmission and liberate it from all provided intermediate clamps, do not take the rubber plug through passage from a partition of an impellent compartment.
  4. Check up a cable condition, — the cable should move freely in a cover.

The cable removed from the car can look and function quite regularly, however to begin заедать at bending. In case of need replace a cable.

Installation

 PERFORMANCE ORDER

  1. Get a cable on the regular place, having passed it in the plug through passage in a partition of an impellent compartment. Fix a cable in a lever plate.

For simplification of dragging of a cable through the plug through passage preliminary grease with its soap solution.

  1. Pass the end of a cable moved to transmission in a basic arm and fix a cover a clamp. Connect a cable tip to the lever and (at a corresponding complete set) fix its clamp.
  2. In car salon fix a cover of a cable a clamp and connect a tip to the hinge of the lever of the selector.
  3. Adjust length of a cable (Adjustment of the mechanism of a choice of transfers see).
  4. Establish the central console and other acting in film components.