Opel Astra, Zafira

Since 1998 of release

Repair and car operation


Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
- Automatic transmission
   Specifications
   Adjustment of the mechanism of a choice of transfers
   Removal and installation of a cable of a choice of transfers
   Removal and installation of assemblage of the lever of selector AT
   Replacement of epiploons
   Cooler ATF - the general information
   Removal and installation of electric components of control system АТ
   Removal and installation АТ
   Major repairs АТ - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of assemblage of the lever of selector AT

The description of procedure of replacement of switches of modes – see Removal and installation of electric components of control system АТ.

Removal

 PERFORMANCE ORDER

  1. Remove the central console (the Body see the Head), then translate the selector lever in position «P».
  2. Disconnect electroconducting from switches of modes and liberate a cartridge of a lamp from the display panel.
  3. Accurately having hooked a screw-driver, separate a tip of a cable from the lever hinge. Shift a clamp and liberate a cable from a basic arm in front of the lever.
  4. Turn out four fixing screws and remove lever assemblage.
  5. Check up knot on presence of signs of deterioration and damages. Give a nut, remove a washer and take axis knot. Release clamps of fastening of the display panel, separate lever knot with a basic arm. Fuller dismantling of knot is not represented possible.

Installation

 PERFORMANCE ORDER

  1. In case of need establish on lever assemblage a basic arm. Insert an axis. Establish a washer and tighten a fixing nut with demanded effort. Strengthen the display panel on a basic arm. Before lever installation on the car check up serviceability of functioning of assemblage.
  2. Establish lever knot on the regular place, connect a selector cable. Screw fixing bolts and tighten them with demanded effort.
  3. Fix a cable of the selector a clamp and connect a cable tip to the lever hinge.
  4. Having tracked correctness of a lining of a plait, lay electroconducting, establish a cartridge пампы on the display panel and restore initial connection of electroconducting.
  5. Adjust a cable valley (Adjustment of the mechanism of a choice of transfers see), then establish into place the central console (the Body see the Head).