- Merge from the fuel filter дизтопливо (Removal of a sediment from the fuel filter of the diesel engine see).
|
- Disconnect electroconducting from the thermosensitive gauge-switch and an element of heating of the filter, established between the fuel filter and its basic arm.
- Slightly ослабьте the central bolt of fastening of the filter, open штуцерные sockets of fast joining and disconnect from the filter hoses.
|
|
- Remove the case of the filter from a basic arm.
- Lower the filter case in suitable drain capacity, then turn out the central bolt, give the bottom nut and merge the fuel rests (the Design of the fuel filter see an illustration).
- Uncover also a sealing ring, take filtering element, a spring and the bottom sealant, — sealing elements are subject to replacement without fail (the Design of the fuel filter see an illustration).
- Carefully clean the filter case.
- Plant in the case the bottom sealant and a spring, at corresponding execution fill in the case the bottom nut (the nut of one type is built in the bottom sealant, another — наворачивается on the end of the central bolt).
- Fill in the case a new filtering element, then, whenever possible, fill the filter case pure дизтопливом for simplification of a problem of removal of air from a power supply system path, — in an ideal level of the filled in fuel should reach the top cut of the case.
- Plant on the case a cover (do not forget to plant a new sealing ring), then establish the central bolt, — still check position of a sealing ring. Tighten a bolt with demanded effort, — do not suppose cover deformation.
- Start the engine and pump over the power supply system (see the Head of the Power supply system and release).
|
|