Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   - The power supply system
      Sbrasyvanie pressure in the power supply system of petrol engines
      Check of a condition and replacement of fuel lines and them штуцерных connections
      Removal of air from a fuel path of the diesel engine
      Removal of pollution from the power supply system of the diesel engine
      Removal and installation of components of an inlet air path
      Removal, installation and adjustment of a cable of gas - petrol models
      Removal and installation of a pedal of an accelerator
      Removal and installation of the fuel pump - petrol models
      Removal and installation of the gauge of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle - petrol models
   + System of injection of fuel of petrol engines
   + Systems of injection and turbo-supercharging of the diesel engine
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal of air from a fuel path of the diesel engine

Removal of air after filling of a path of the power supply system occurs automatically, than and absence of gates of prorolling speaks.

 PERFORMANCE ORDER

  1. Start the engine (procedure can occupy a bit more time, than usually, especially, if fuel from system has been completely merged, — turn a cranked shaft a starter not longer 10 seconds, in case of need repeat attempt, having waited not less than 30 seconds) and allow to it to work to steam of minutes on fast single turns. After air stoppers will be completely removed from a power supply system path, stability of turns of idling should be restored.
  2. Insufficient stability of functioning of the engine testifies that all air left a path, — on pair minutes lift engine turns, then again dump them to the single. Continue prorolling until demanded stability of single turns will be reached.