Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation дефлекторов air lines
      Removal and installation of resistive assemblage приводного the electromotor of the fan of a heater
      Removal and installation приводного the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating / of ventilation / of an air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of a central air of air
      Removal and installation of the evaporator of a central air of air
      Removal and installation of the condenser of a central air of air
      Removal and installation of a receiver-dehumidifier of a central air of air
      Removal and installation of the additional fan
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the evaporator of a central air of air

Air central air constantly is under a high pressure. At all do not disconnect refrigerator lines and do not remove any components of system, preliminary without having executed a discharge of last. The discharge of a central air of air should be made by forces of the skilled expert in the conditions of a car-care centre workshop. At рассоединении refrigerator lines necessarily put on goggles!


At replacement of components of a central air of air the certain quantity of replaceable refrigerator oil necessary for filling of volume of new knot is required. Use only the oil suitable for the use in systems R-134a (attentively study a label on the container).

Removal

Models Astra

 PERFORMANCE ORDER

  1. Make a discharge of a central air in the conditions of a specialised workshop.
  2. On petrol engines of 1.6 l SOHC remove an inlet air line from the case throttle заслонки (see the Head of the Power supply system and release).
  3. In a back part of an impellent compartment turn out штуцерный a bolt of fastening of a refrigerator line to термостатически to the operated broad valve. Screw a bolt and take the valve. Remove a sealing element. At once stick with an adhesive tape, or закупорьте apertures in order to avoid hit in dirt system.

At valve installation it is necessary to insert two directing cores, - experts of car-care centre for the purpose of prevention of risk of damage of a tube usually use for запрессовки connections in the valve adaptation Opel KM-6012.

  1. Remove a ware box and the bottom sections of furnish of the panel of devices (the Body see the Head).
  2. Remove the heater fan (Removal and installation приводного the electromotor of the fan of a heater see).
  1. Remove салонный the filter (Routine maintenance see the Head), then, - at a corresponding complete set, - disconnect electroconducting from the gauge of heating of glass.
  1. Turn out fixing screws and uncover the evaporator, - pay attention that the cover is planted on hermetic, all to which trace should be carefully removed from interfaced surfaces.

On some models for removal of a cover of the evaporator it is necessary to take advantage of a knife.

  1. At a corresponding complete set remove the gauge of heating of glass, - try to remember its adjusting position. Accurately take the evaporator from the heater case.

Models Zafira

Some models are equipped also by the back evaporator established behind a back quarter of the protective panel.


 PERFORMANCE ORDER

  1. Make a discharge of a central air in the conditions of a specialised workshop.
  1. In a back part of an impellent compartment turn out штуцерный a bolt of fastening of a refrigerator line to термостатически to the operated broad valve. Screw a bolt and take the valve. Remove a sealing element. At once stick with an adhesive tape, or закупорьте apertures in order to avoid hit in dirt system.

At valve installation it is necessary to insert two directing cores, - experts of car-care centre for the purpose of prevention of risk of damage of a tube usually use for запрессовки connections in the valve adaptation Opel KM-6012.

  1. Turn out bolts of fastening of a cover салонного the filter and the evaporator, at a corresponding complete set, disconnect electroconducting from the gauge of heating of glass.
  1. Remove the filter.
  1. At a corresponding complete set remove the gauge of heating of glass, - try to remember its adjusting position. Accurately take the evaporator from the heater case.

Installation

Installation is made in an order, the return to an order of dismantle of components. The central air gymnastics should be made in the conditions of the car-care centre workshop which experts will establish as well the broad valve.

For installation of a cover of the evaporator special hermetic is required, - consult at experts of firm car repair shop Opel.