Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation дефлекторов air lines
      Removal and installation of resistive assemblage приводного the electromotor of the fan of a heater
      Removal and installation приводного the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating / of ventilation / of an air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of a central air of air
      Removal and installation of the evaporator of a central air of air
      Removal and installation of the condenser of a central air of air
      Removal and installation of a receiver-dehumidifier of a central air of air
      Removal and installation of the additional fan
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of the switch of a heater

 PERFORMANCE ORDER

  1. Remove the control panel a heater (Removal and installation of the control panel by functioning of systems of heating / of ventilation / of an air conditioning see).
  2. Result the handle of a choice of a temperature mode in vertical position (Heating). By means of the second handle of management choose a direction of giving of air on obverse level.
  3. Accurately remove the handle of a choice of a high-speed mode of functioning of the fan of a heater.
  1. Hooking a screw-driver, release clamps from the back party of the control panel and remove the switch.

Installation is made upside-down.