Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation дефлекторов air lines
      Removal and installation of resistive assemblage приводного the electromotor of the fan of a heater
      Removal and installation приводного the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating / of ventilation / of an air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of a central air of air
      Removal and installation of the evaporator of a central air of air
      Removal and installation of the condenser of a central air of air
      Removal and installation of a receiver-dehumidifier of a central air of air
      Removal and installation of the additional fan
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of resistive assemblage приводного the electromotor of the fan of a heater

 PERFORMANCE ORDER

  1. Remove a ware box (the Body see the Head).
  2. Remove the bottom section of furnish of the panel of devices from outside the passenger, then if it is required, release a clamp and remove a heater air line.
  3. Uncover and take a working element салонного the filter, - covers of two types are applied, in one of which hermetic sealing of landing of a cover is provided by means of hermetic. Alternatively remove приводной the electromotor of the fan of a heater (Removal and installation приводного the electromotor of the fan of a heater see).
  1. Accurately push out resistive assemblage upwards, disconnect electroconducting and take the resistor from the case.

    A — the Site of resistive assemblage of the fan of a heater (execution)
    B — the Site of resistive assemblage of the fan of a heater (execution)

A.

B.

Installation is made upside-down. On in appropriate way the equipped models do not forget to put hermetic on a cover салонного the filter.