Opel Astra, Zafira

Since 1998 of release

Repair and car operation


Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation дефлекторов air lines
      Removal and installation of resistive assemblage приводного the electromotor of the fan of a heater
      Removal and installation приводного the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating / of ventilation / of an air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of a central air of air
      Removal and installation of the evaporator of a central air of air
      Removal and installation of the condenser of a central air of air
      Removal and installation of a receiver-dehumidifier of a central air of air
      Removal and installation of the additional fan
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation приводного the electromotor of the fan of a heater

Removal

Electromotor "Delphi"

 PERFORMANCE ORDER

  1. Remove a ware box (the Body see the Head).
  2. Remove the bottom section of furnish of the panel of devices from outside the passenger, then if it is required, release a clamp and remove a heater air line.
  1. Remove the bottom protective panel from the obverse panel from outside the passenger. Release a clamp and remove an air line from outside heater cases.
  1. Temporarily include ignition and choose a mode of the closed air circulation (the Operation manual see). Switch off ignition, then disconnect electroconducting and приводную draught from the servomotor заслонки a choice of modes of circulation.
  1. Turn out fixing screws.
  1. Cнимите the servomotor.

New servomotors are established at factory in position of the closed circulation.

  1. Disconnect electroconducting from приводного the electromotor of the fan of a heater.
  1. Turn out three fixing bolts, release clamps and take the electromotor from the case.

    A — Bolts of fastening of a cover of the case of the fan of a heater (execution)
    B — Bolts of fastening of a cover of the case of the fan of a heater (execution)

A.

B.

Electromotor "Behr"

 PERFORMANCE ORDER

  1. Temporarily include ignition and choose a mode of the closed air circulation (the Operation manual see). Switch off ignition, then disconnect electroconducting and приводную draught from the servomotor заслонки a choice of modes of circulation, turn out fixing screws and remove the servomotor.

New servomotors are established at factory in position of the closed circulation.

  1. Turn out five fixing bolts and release a clamp. Take the electromotor from the case вентиляторной assemblages, - pay attention that hermetic keeps within a case flute, - carefully clean a flute.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. At installation of motor Behr do not forget to fill with hermetic a reception flute on the assemblage case. Track, that the main gear wheel of the servomotor has entered in the correct image into gearing with the main gear wheel заслонки.