Opel Astra, Zafira

Since 1998 of release

Repair and car operation

Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   - Electronic control system of ignition (and injection) petrol engines
      Checks of serviceability of functioning of system of ignition
      Diagnostics of malfunctions - the general information and preliminary checks
      System of onboard self-diagnostics OBD - the general information
      Application of an oscillograph for supervision of workers of a control system
      Removal and installation of the module of ignition
      Check and installation of a corner of an advancing of ignition
      Removal and installation of the switch of ignition
      Removal and installation of the gauge of emergency pressure of oil
      Removal and installation of the gauge of level of impellent oil
      Removal and installation of the gauge of temperature of impellent oil (diesel models)
   + Systems of preheat and heating of fuel of the diesel engine
   + Charge and start systems
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the module of ignition


Engines of 1.6 l SOHC and 2.0 litres DOHC


  1. Disconnect a negative wire from the battery.
  1. Disconnect from the module of ignition electroconducting and high-voltage wires. Conclusions of the module and a plait wire are numbered that excludes probability of wrong connection at installation.

    A — the ignition Module (the engine of 1.6 l SOHC)
    B — the ignition Module (the engine of 2.0 l DOHC)


  1. Turn out fixing bolts and remove the module of ignition from a head of cylinders.

Engines 1.4, 1.6 and 1.8 l DOHC


  1. Give fixing bolts, uncover маслозаливной mouths a protective casing of the engine.
  1. The module is established from above on a head, between inlet and final camshafts, - disconnect electroconducting from a module left-hand side.

    Socket of electroconducting-2 modules of ignition-3 (engines 1.4, 1.6 and 1.8 l DOHC)

  1. Turn out fixing screws and remove the module, - on engines of 1.4 and 1.6 l the left bolt of fastening is used also for interference suppressor fixing. If the module "has become attached" and does not give in to removal, screw in its top apertures pair of bolts М8 and separate assemblage from candles, having pulled nippers for their heads.


Installation is made upside-down.


  1. Track, that all fixture has been tightened with demanded effort.
  2. On engines of 1.6 l SOHC and 2.0 l DOHC according to numbering attach to the conclusions to module VV electroconducting.
  3. Attach to the module electroconducting.
  4. Connect a negative wire to the battery.