Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   - Electronic control system of ignition (and injection) petrol engines
      Checks of serviceability of functioning of system of ignition
      Diagnostics of malfunctions - the general information and preliminary checks
      System of onboard self-diagnostics OBD - the general information
      Application of an oscillograph for supervision of workers of a control system
      Removal and installation of the module of ignition
      Check and installation of a corner of an advancing of ignition
      Removal and installation of the switch of ignition
      Removal and installation of the gauge of emergency pressure of oil
      Removal and installation of the gauge of level of impellent oil
      Removal and installation of the gauge of temperature of impellent oil (diesel models)
   + Systems of preheat and heating of fuel of the diesel engine
   + Charge and start systems
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the gauge of emergency pressure of oil

Removal

Petrol models and diesel models 1.7 of l SOHC

The gauge will screw in a back part of the case of the oil pump.

 PERFORMANCE ORDER

  1. At a corresponding complete set turn out fixing bolts and remove protection картера.
  2. Disconnect from the gauge electroconducting.
  1. Turn out the gauge, - prepare for gathering of spilt fuel. If the gauge acts in film for long time, закупорьте an aperture under its installation approaching заглушкой.

    1 — the Contact socket of electroconducting
    2 — the Gauge

Diesel models 1.7 of l DOHC

 PERFORMANCE ORDER

  1. The gauge will screw in the left part of the block of cylinders, more low and hardly behind the thermostat case, - for the purpose of maintenance of adequate access, remove the storage battery with the adjusting pallet (Check of serviceability of functioning of system of preheat see).
  1. Disconnect electroconducting and turn out the gauge, - prepare for gathering of spilt fuel. If the gauge acts in film for long time, закупорьте an aperture under its installation approaching заглушкой.

Diesel models 2.0 of l

 PERFORMANCE ORDER

  1. At a corresponding complete set remove protection картера.
  2. The gauge will screw in a back part of the block of cylinders, over a power shaft, - disconnect from it electroconducting.
  1. Turn out the gauge, - prepare for gathering of spilt fuel. If the gauge acts in film for long time, закупорьте an aperture under its installation approaching заглушкой.

    1 — the Contact socket of electroconducting
    2 — the Gauge

Installation

 PERFORMANCE ORDER

  1. Slightly grease a carving part of the gauge with fixing hermetic.
  2. Screw the gauge on the regular place and tighten it with demanded effort. Attach electroconducting.
  3. On petrol models and diesel models 1.7 of l SOHC and 2.0 l establish protection картера.
  4. On engines of 1.7 l DOHC establish the storage battery with the pallet (Check of serviceability of functioning of system of preheat see).
  5. Check up oil level in the engine, in case of need make corresponding updating (Routine maintenance see the Head).