Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of an electric equipment
Safety locks - the general information
The relay - the general information and check of serviceability of functioning
Removal and installation of switches
Replacement of lamps of external lighting and alarm devices
Replacement of lamps of internal lighting devices
Removal and installation of external lighting/alarm devices
Adjustment of a direction of optical axes of headlights
Removal and installation of a combination of devices
Removal and installation of components of the panel of devices
Removal and installation прикуривателя
Removal and installation of small horns of a horn
Removal and installation of levers (leads) of screen wipers
Removal and installation of elements of a drive of screen wipers
Removal and installation of components of system of washing of glasses
Check of serviceability of functioning and regenerative repair of a heater of back glass
Removal and audiosystem installation / the navigating block
Removal and installation of elements of remote control by audiosystem functioning
Removal and installation of loudspeakers
Removal and installation of the aerial of a radio receiver
Anticreeping system and system immobilization the engine - the general information
The gauge of speed of movement of the car (VSS) - the general information
System of additional safety (SRS) - the general information
Removal and installation of elements SRS
Schemes of electric connections - the general information
+ Basic schemes of electric connections
|
Replacement of lamps of internal lighting devices
At replacement of any lamp, pay attention to following moments:
- Remember that flasks of lamps remain hot within nearby 20 minutes after switching-off of lighting devices. Before to start to work make sure that components have definitively cooled down;
- Try to take lamps only for a socle, - remember that at a flask contact naked fingers on glass there are fatty stains that leads to a premature exit of a lamp out of operation as a result of an overheat. Before installation wipe a flask of a lamp spirit;
- Always check a condition of socles of lamps and contacts of cartridges, before lamp installation without fail smooth out contact surfaces, completely deleting from them a dirt and corrosion traces;
- Watch that the replaceable lamp in accuracy corresponded failed on the electric characteristics (pressure of a food and capacity).
Forward салонный the fixture
|
|
- On models Astra, accurately having hooked a screw-driver, remove from the fixture. Liberate the failed lamp фестонного type from the spring contacts.
|
|
- On models Zafira, accurately having hooked a screw-driver, remove the fixture from the panel of a ceiling / of a cover of access to the electromotor of a drive of the top hatch). Disconnect electroconducting, turn away a cartridge and take from it бесцокольную a lamp.
|
A.
B.
C. |
- Installation is made upside-down.
|
|
Back салонный the fixture
|
|
- Accurately having hooked a screw-driver / having released a clamp, liberate the fixture from a ceiling upholstery.
- Liberate a lamp фестонного type from spring contacts.
|
A.
B. |
- Installation is made upside-down, - in case of need turn in in appropriate way contacts.
|
|
Luggage space illumination
|
|
- Accurately having hooked a screw-driver, liberate the fixture from the panel of an internal upholstery.
- Liberate a lamp фестонного type from spring contacts.
- Installation is made upside-down, - in case of need turn in in appropriate way contacts.
|
|
Illumination of a ware box
|
|
- Open a door of a ware box and, accurately having hooked a screw-driver, liberate the internal fixture from the lateral panel.
|
|
- Liberate a lamp фестонного type from spring contacts. In case of need disconnect electroconducting and take the fixture from a box.
- Installation is made upside-down, - in case of need turn in in appropriate way contacts.
|
|
Back lamp for reading
|
|
- Accurately having hooked a screw-driver, take out the fixture from the landing nest.
|
|
- Liberate a lamp фестонного type from spring contacts.
- Installation is made upside-down, - in case of need turn in in appropriate way contacts.
|
|
Illumination прикуривателя
|
|
- Having released clamps, remove the decorative panel established under an ashtray.
- Open an ashtray, turn out fixing screws and remove the case of an ashtray from forward section of the central console. Disconnect from прикуривателя electroconducting.
|
- Remove a spiral прикуривателя, then, having hooked a screw-driver through a small aperture, release an illumination ring.
|
|
- Remove a cartridge and take a lamp.
- Installation is made upside-down.
|
|
Illumination of devices and control lamps
|
|
- Remove a combination of devices (see Has undressed Removal and installation of a combination of devices).
|
- Turn a cartridge of the failed lamp and liberate it from the panel of a combination of devices. Take a lamp from a cartridge and make its replacement.
|
|
|
|
Some lamps are united with the cartridge in uniform assemblage. |
|
- Installation is made upside-down.
|
|
Illumination of switches
|
|
- Remove the button of the corresponding switch (see Has undressed Removal and installation of switches).
|
- By means of tweezers turn out a cartridge of a lamp from a back part of the switch.
|
|
- Installation is made upside-down.
|
|
Illumination of hours / of the multipurpose display
Illumination of the control panel by functioning of systems of heating / of ventilation and air-conditioning
|
|
- Remove the control panel a heater (see the Head of System of cooling, heating).
|
- Take from the control panel the failed lamp.
|
|
- Installation is made upside-down.
|
|
|
|