Removal, installation and adjustment of the gauge-switch of stoplights
Removal
The gauge-switch is fixed on an arm of a pedal of a foot brake.
|
- Remove the bottom section of furnish of the panel of devices (the Onboard electric equipment see the Head). For the purpose of maintenance of adequate access disconnect an air line.
|
- Disconnect from the gauge-switch electroconducting, turn the switch and liberate it from an arm of pedal assemblage.
|
|
|
Installation and adjustment
|
- Before installation completely drown плунжер the gauge-switch.
- Establish the gauge-switch on an arm of a pedal and turn for fixing.
- Squeeze out a pedal of a foot brake and take плунжер against the stop it in the pedal lever. For adjustment end release a pedal.
- Connect electroconducting, establish an air line and the bottom section of furnish of the panel of devices. Check up serviceability of functioning of the gauge-switch on operation of stoplights at squeezing of a pedal of a foot brake.
|
|
|