Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement ступичной assemblages
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation back ступичной assemblages
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation торсионной beams of a back suspension bracket
   Replacement резинометаллических hinges of longitudinal levers торсионной beams
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (model the Versatile person)
   Removal and steering wheel installation
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers картера the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from hydraulic path ГУР
   Removal and installation of tips of steering draughts
   Removal and installation of steering draught
   Corners of installation of wheels
+ Body
+ Onboard electric equipment



Replacement резинометаллических hinges of longitudinal levers торсионной beams

Replacement резинометаллических hinges should be made in pairs.

Removal

 PERFORMANCE ORDER

  1. Remove торсионную a beam (Removal and installation торсионной beams of a back suspension bracket see).
  2. Before removal of hinges by a chisel beat out prorates from internal surfaces of levers.
  3. Is better to make dismantle резинометаллических hinges by means of special tool Opel though not less effectively it is possible to take advantage of a long bolt with a nut, a washer and a piece of a pipe or a replaceable face head of suitable diameter. Try to remember adjusting positions of hinges, before выпрессовывать them from levers.

Installation

 PERFORMANCE ORDER

  1. Grease new hinges with silicone greasing or soap water and запрессуйте them in levers.
  2. Establish into place a beam (Removal and installation торсионной beams of a back suspension bracket see).