Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement ступичной assemblages
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation back ступичной assemblages
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation торсионной beams of a back suspension bracket
   Replacement резинометаллических hinges of longitudinal levers торсионной beams
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (model the Versatile person)
   Removal and steering wheel installation
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers картера the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from hydraulic path ГУР
   Removal and installation of tips of steering draughts
   Removal and installation of steering draught
   Corners of installation of wheels
+ Body
+ Onboard electric equipment



Removal and installation of the forward stabilizer of cross-section stability

Composers of the present Management recommend to make replacement of all carving fixture without fail.

Removal

 PERFORMANCE ORDER

  1. Remove a forward stretcher (Removal and installation of a forward stretcher see).
  1. Mark adjusting position of vertical draughts of the stabilizer. Release fixing nuts and disconnect draughts from a stabilizer bar, - at отпускании nuts keep шарнирный a finger of draught from проворачивания the second key for specially provided лыски.
  1. Turn out bolts of collars of fastening of a bar of the stabilizer to a stretcher.

"The become attached" bolts can be cut off with the subsequent drilling of the rests, - at assemblage it is necessary to take advantage of inserts (consult with experts of car-care centre).

  1. Remove a bar of the stabilizer of cross-section stability from a stretcher.
  2. Remove from a stabilizer bar rubber plugs, - try to remember adjusting position of components.
  3. Study a condition of a bar of the stabilizer, its vertical draughts and rubber plugs. The worn out or damaged components replace.

Installation

Installation is made in an order, the return to an order of dismantle of components. Pay attention to following moments.

 PERFORMANCE ORDER

  1. Rubber plugs should be established on a stabilizer bar by cutting locks forward.
  2. Track, that all carving fixture has been replaced and will tighten with demanded effort.
  3. Installation of a forward stretcher make according to instructions (Removal and installation of a forward stretcher see).