Opel Astra, Zafira

Since 1998 of release

Repair and car operation



Opel Astra
+ Cars Opel Astra and Zafira
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement ступичной assemblages
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation back ступичной assemblages
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation торсионной beams of a back suspension bracket
   Replacement резинометаллических hinges of longitudinal levers торсионной beams
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (model the Versatile person)
   Removal and steering wheel installation
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers картера the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from hydraulic path ГУР
   Removal and installation of tips of steering draughts
   Removal and installation of steering draught
   Corners of installation of wheels
+ Body
+ Onboard electric equipment



System of adjustment of a road gleam of a back axis - the general information and adjustment

The general information

The given system is established on models the Versatile person and provides possibility of updating of size of a road gleam of a back axis of the car depending on degree of its loading. Updating is made by adjustment of pressure of air in back shock-absorbers by means of the operated valve established on the right in a luggage space.

From reasons of safety air should not be in a working path of system under the maximum pressure if the car is not loaded completely.

Adjustment

 PERFORMANCE ORDER

  1. Unload the car and measure pressure in system шинным by a manometre. Nominal pressure makes 0.8 bar. In case of need make corresponding updating.

Pressure in system never should fall below value 0.8 bar!

  1. Park the car on an equal horizontal surface, it is desirable with a firm covering and measure distance I from an upper edge of a back bumper to the earth. Subtract from the received value of 50.0 mm and write down result.
  2. Lay in the car the prepared luggage if it is required, correct pressure in system, achieving demanded value of the measurement described in the previous paragraph.

Do not lift pressure in a system path from above 5.0 bar!

  1. After unloading of the car do not forget to dump pressure to nominal level (0.8 bar).